Operating instruction is as follows:
1. Extending supporting legs preventing inclination connected on the four corners of
chassis to greatest extent outward till it reaches maximum angle.
2. Rotating the handle clockwise till the supporting base of the four supporting screws
contacts the ground, rotating the handle continually till the road wheel leaves ground.
3. Adjusting horizon through observing the level on the chassis. The blister should in the
central circle of the level when the chassis is in horizontal position.
If it needs to close up supporting legs preventing inclination, rotating the handle
clockwise till supporting foot leaves the ground, when closing up inward and nearing the
wall of chassis, the magnet on the wall will absorb supporting legs to prevent supporting
legs shaking in transportation.
Warning: Be sure to observe the level on the
Chassis, the blister should in the
central circle of the level.
Warning: Any operation is prohibited before
unfolding supporting legs preventing
inclination.
