Warehouse Wall Vibrator Anti-occlusion device work, is to vibration motor as the source of energy-saving through the product, it is based on high-frequency vibration and impact, effectively eliminate due to internal friction, moisture solution, charge, component segregation and other reasons caused by the bridge, Arch, blockage and other phenomena, so that the material from the warehouse mouth smoothly discharged, to ensure the stability of the
ZFB Series anti-occlusion devices are widely used in metallurgy, chemical industry, building materials, thermal power, coal, food, cement, pharmaceutical, fertilizer, grain, casting, ceramics, abrasives and other industries in the storage silo for anti-occlusion.
1, Observe the ZFB explosion-proof motor silo Wall Vibrator Device anti-occlusion ability. Check whether the material surface in the silo is "full cup" or still have occlusion phenomenon, if there is, it should reduce the angle of the eccentric block of the vibrating motor, that is, increase the excitation force. But the excitation force should not be too big.
It is appropriate not to produce occlusion, otherwise it is unfavorable to each vibration component.
2, In the lower part of the silo has feeder discharge, the control equipment should ensure that the feeder first operation, ZFB explosion-proof motor silo wall vibration device after operation.
3, ZFB explosion-proof motor silo wall vibrator on the vibration motor because the connection is too tight or due to the use of negligence, will cause the vibration motor to suffer mechanical damage, may occur disconnection, generally occur in the case of disconnection, technical personnel can first check the junction box, if the location of the broken wire is in the inside of the vibrating motor, Should be in accordance with the general Motor line inspection methods to carry out maintenance work. If necessary, the entire stator also needs to be pressed out before it can be overhauled, and when pressing the vibrating motor stator, the appropriate tools must be in place. Vibration motor bearings After a period of time operation, may gradually occur wear and tear, the need to replace it, bearing if the wear is excessive, will lead to the rotor and stator friction and thus damage, this case must be immediately replaced by the bearing, factory manufacturers installed the bearing accuracy is relatively high, When changing bearings, the quality of the bearings should also be guaranteed.
